Cutting List Calculator – Stock Lengths

Stock length
Pieces to cut
Pieces
#1
#2
#3

Pieces are placed longest first into the first length with room (first-fit decreasing). Offcuts in the cutting plan include the saw kerf.

Stock lengths to buy4
Material used86.7%
Offcuts in total3.16m
Stock lengths
Stock lengths needed4
Theoretical minimum (total length ÷ stock length)4
Total stock length24 m
Pieces and offcuts
Pieces to cut15
Total length of pieces20.8 m
Lost to the saw kerf45 mm
Offcuts in total3.16 m
Longest single offcut1,988 mm
Material used (pieces ÷ stock)86.7 %
Cutting plan

6,000 mm stock length (offcut shown includes saw kerf)

Stock length #1Offcut 400 mm
Stock length #2Offcut 400 mm
Stock length #3Offcut 400 mm
Stock length #4Offcut 2,000 mm
Parts
#PieceSizeQty
1Piece2,400 mm × 50 mm4
2Piece1,200 mm × 50 mm6
3Piece800 mm × 50 mm5

About this calculator

Timber, battens, steel profiles, pipe and rails are sold in stock lengths – often 3, 4.5 or 6 m. This calculator takes your cutting list (each piece length and how many of it) and works out how many stock lengths to buy and where to cut each piece, allowing for the width of the saw cut (the kerf). The cutting plan shows every length with its pieces and the offcut left at the end.

Formula

Pieces are sorted longest first and each is placed on the first length that still has room for it (the first-fit decreasing method). A length holds a set of pieces when

sum of piece lengths + (number of pieces − 1) × kerf ≤ stock length

– a piece may end exactly at the far end of the length without a final cut.

material used       = total length of pieces ÷ (stock lengths × stock length) × 100 %
theoretical minimum = ⌈ Σ (piece + kerf) ÷ (stock length + kerf) ⌉

Worked example

6 m lengths, 3 mm kerf; 4 pieces of 2400 mm, 6 of 1200 mm and 5 of 800 mm:

length 1: 2400 + 2400 + 800          offcut 391 mm
length 2: 2400 + 2400 + 800          offcut 391 mm
length 3: 1200 + 1200 + 1200 + 1200 + 800   offcut 385 mm
length 4: 1200 + 1200 + 800 + 800    offcut 1988 mm
→ 4 lengths, 20.8 m of pieces from 24 m: 86.7 % used, 45 mm lost to the saw

The theoretical minimum is also 4, so no arrangement can do better.

FAQ

Is this always the best possible cutting plan? Not always. First-fit decreasing is a proven, fast method that is usually optimal or one length off. When the plan needs more lengths than the theoretical minimum, the calculator tells you.

What kerf should I enter? The thickness of the saw blade's cut: a circular saw or mitre saw blade is typically a few millimetres. Enter 0 to ignore it.

Should I add extra for mistakes? The count is exact for the pieces you list. Add a spare length yourself if the material has defects to cut out or you want a margin.

What is the profile width for? Only for drawing the cutting plan; it does not change the result.

Assumptions and limits

  • Every stock length is the same and usable from end to end (no damaged ends to trim).
  • Pieces are cut square across the length; mitres and angled cuts are not modelled.
  • Up to 30 piece sizes and 500 pieces of each size.