Drain Pipe Gradient and Fall Calculator

Pipe run and gradient
Known value
Depths below level ground

This is geometry only. The gradient a drain actually needs depends on its size and filling and on national rules and the pipe manufacturer – check it there.

Fall over the run200mm
Gradient2.00%
Invert depth at the lower end800mm
Gradient
Gradient (fall ÷ run × 100)2.00 %
Fall per metre of run20 mm
Ratio 1 : x (x = run ÷ fall)50.0
Angle1.15°
Lengths and depths
LHorizontal run10,000 mm
HFall200 mm
Pipe length along the slope10 m
D1Invert depth, upper end600 mm
D2Invert depth, lower end800 mm

About this calculator

A gravity drain only works if it falls steadily towards its outlet. This calculator turns a gradient into the fall (drop) of the pipe over its run – or a known fall back into the gradient – and gives the same gradient as a 1 : x ratio, in millimetres per metre and in degrees. With the depth of the pipe at its upper end it also gives the depth at the lower end.

  • Run – the horizontal length of the pipe between the two points.
  • Gradient – fall ÷ run × 100, in percent. 2 % is 20 mm per metre, or 1 : 50.
  • Invert depth – the depth from a level ground surface down to the bottom inside the pipe.

Formula

fall          = run × gradient / 100
gradient      = fall / run × 100
fall per metre = gradient × 10        (mm/m)
ratio 1 : x   = 1 : (run / fall)
pipe length   = √(run² + fall²)
lower depth   = upper depth + fall

Worked example

A 10 m drain at 2 %, starting 600 mm deep:

fall        = 10 000 mm × 2 / 100 = 200 mm
ratio       = 10 000 / 200 = 1 : 50  (20 mm/m)
pipe length = √(10 000² + 200²) ≈ 10 002 mm
lower depth = 600 + 200 = 800 mm

FAQ

What gradient does my drain need? It depends on the pipe size, how full it runs and the rules that apply where you build – check the national rules and the pipe manufacturer's guidance. This calculator only does the geometry.

Is a steeper drain always better? No. Too steep a pipe can let water run ahead of solids. Stay within the range the rules and the pipe manufacturer give.

Why is there no drawing? A drain profile is metres long but only centimetres deep; drawn to scale it would be a flat line.

Assumptions and limits

  • Level ground: both depths are measured from the same horizontal surface.
  • A straight pipe with one constant gradient between the two ends.
  • Gradients from 0.1 % to 50 %.